Network Cabling Installation in Toronto & GTA

Network cabling Installation

Network Cable Installation for Toronto & GTA Homes

Alarmto installs network cable in homes across Toronto and the GTA. We run Ethernet from your network equipment to each spot that needs a wired connection, then terminate and test every run.

Typical connections include Wi-Fi access points, security cameras, TVs, and home-office computers. How many runs you need, and where they go, depends on the layout of the house and where the equipment will sit.

Ethernet Cable

Ethernet Cable Types: Cat5e, Cat6, and Cat6a

Cat5e, Cat6, and Cat6a are the Ethernet cable categories commonly used in residential network installations.

Cat5e supports Gigabit Ethernet and can be a practical choice for standard network connections and extending an existing network.

Cat6 supports Gigabit Ethernet and can support 10 Gbps over shorter runs, depending on the equipment and installation conditions.

Cat6a supports 10 Gbps over runs up to 100 metres. It is a good option when higher bandwidth is needed over longer runs or when additional capacity is planned for future equipment. Cat6a is also thicker and more difficult to route.

We select the cable based on the equipment, run length, network hardware, and installation conditions rather than using the same cable for every job.

PoE Cabling

PoE Cabling for Cameras and Wi-Fi Access Points

Power over Ethernet (PoE) sends power and data to a device over a single Ethernet cable. It's most often used for IP security cameras and Wi-Fi access points, so neither needs an outlet nearby.

The power comes from a PoE switch, a PoE-enabled NVR, or a PoE injector. Before we run any cable, we check the devices and their power requirements to confirm the setup is compatible. If you're adding cameras, see our security camera installation service.

Network Racks & Cabinets

Home Network Rack & Cabinet Installation

A home network rack or cabinet keeps network equipment and cable connections organized in one location. Depending on the setup, it can house a router, network switch, patch panel, and connections for Ethernet outlets, Wi-Fi access points, and other wired devices.

Alarmto installs and organizes residential network cabinets based on the available space, number of connections, equipment, and plans for future expansion. We also organize and label cable connections to make the home network easier to maintain.

New homes

New Homes, Renovations & Existing Homes

• New builds and renovations: cable can go in while the walls are open, so routes and connection points are planned before drywall.
• Existing homes: we look for routes through basements, attics, utility spaces, and existing pathways. Depending on how the home was built, some runs can be done without opening finished walls.